|
Tractor Talk Discussion Board |
Re: CONTROL SPEED PLATE FOR FORD 8N
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Slowpoke on February 10, 2004 at 00:28:33 from (67.30.99.6):
In Reply to: CONTROL SPEED PLATE FOR FORD 8N posted by JOHN KNIGHT on February 09, 2004 at 14:43:26:
Will this work? Get a small piece of ribbed rubber floor mat, set it on the lever quadrant with the ribs parallel to the gas lever. Mark it underneath, cut it to the circular shape and glue it to the metal.
Or, cut a 2" length of 5/16 fuel hose, slit it down the side and place it over the gas lever.
Glue or tape it down between the lever and quadrant.
It might get you by till a new one turns up.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
