|
Tractor Talk Discussion Board |
Re: Clean With Air?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil S. on January 31, 2004 at 16:36:25 from (65.26.185.21):
In Reply to: Clean With Air? posted by Joe Wood on January 31, 2004 at 14:51:02:
Yes there are tools you could use with a shop air compressor.. You can buy an "Air wand". This is like a small blow gun. The big difference is that it is about 3 feet long. The trigger is at one end and the air nozzle at the other end. It works good for reaching into areas. The other thing you might consider is renting an industrial compressor.. one that is used to run jack hammers, etc. These usually have a 1" hose and run at 100psi with a large volumne of air. There are different nozzle ends available for them as well. We use one to blow out/off the combine at the end of the harvesting season. It does a great job and is alot more effecient that using our shop compressor. Just an idea. Phil
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
