Tractor Talk Discussion Board |
Re: A questions for Dads
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KB on January 29, 2004 at 16:37:17 from (24.3.62.224):
In Reply to: A questions for Dads posted by Youngster on January 29, 2004 at 14:56:15:
I am going to put a slightly different spin on this. I have 2 sons (18 and 9) and I know I can count on the younger one (even when the older one was the same age the younger one out does him) to do his best job and to carry through til the job is done. I have tried to work with the older one and have come to realize that HE has to make the decision to make something of himself and there is nothing I can do to make this decision for HIM. Therefore, I would suggest that you have decisided to make something of yourself and your dad is teaching you the lessons you need to learn to not only make something of yourself but to ultimately suceede. I know the lessons that you are about to learn are not always going to be pleasant or easy but if you learn them you will only be limited by your imagination. Now that may seem to be a bit of corny but from experience my dad pushed me hard (at times I thought very hard) but I have suceeded and seem to get tapped everywhere I have worked to take on the most chalenging projects because (I will assume) I will get it done and it will be on time, correct and the best that I can offer. The best advise I can offer is don't fight it and soak up everything you can because you never quite know when or where they will come in handy or save your butt!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|