|
Tractor Talk Discussion Board |
Re: 1986 Ford 7610
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kyhayman on January 27, 2004 at 13:28:35 from (24.51.11.221):
In Reply to: 1986 Ford 7610 posted by Noel on January 27, 2004 at 08:14:13:
If it is 2 wheel drive it will have a straight front axle with no large 'bulges' for the differential among many other things (such as no obvious power source going to the front end, 16" front tires, etc). Plenty of transmissions out there, no sure what you would have to pay for one but plent to choose from, clutch will run about from a low of the high $200's to mid $400's to get a top notch rebuild and the going rate here to put a clutch in a 2wd, no cab is $175. Not sure the size of the rear tires but I got a set of 38's put on, on site with fluid put in for $750 and bought a new front for $112 installed. Rims would run from a low of $50 for the fronts up to the mid $100's on the rear (once again 2wd). Figure on towards $2000 assuming the transmission is ok. Price better be mighty right, I bought one in good shape for under $8000 that was a 91 with 3000 hours.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
