|
Tractor Talk Discussion Board |
Re: Re: brass fitting twisted off in block
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray,IN on January 21, 2004 at 18:39:39 from (66.244.73.222):
In Reply to: Re: brass fitting twisted off in block posted by Phil9N on January 21, 2004 at 18:13:16:
A pipe extractor or EZ out will expand the soft brass and hold it that much tighter in the block usually. I'ts still worth a try, just don't over do it and twist off the EZ out, creating a much larger problem. Make sure the EZ out has enough room to bite without bottoming out against a web in the block. Better yet try using a left handed drill bit to drill out the brass leaving only the brass threads to be removed with a small pick. This is where the dentist tools come in real handy that are sold at flea markets. If you're lucky the LH drill will grab and unscrew the brass piece.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
