Tractor Talk Discussion Board |
Re: What part needs heat MOST?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fern(Mi) on January 19, 2004 at 15:13:53 from (64.12.96.236):
In Reply to: What part needs heat MOST? posted by smark on January 19, 2004 at 14:55:42:
Out of desperation I used a dipstick heater on a gas tractor for about 3 weeks 20 below weather. While it got me through that deep freeze I wouldn't recomend it. Haven't used it since. GW. Water heater id most efficeint I'm thinking warming up the compustion chambers for improved vaporization. and the cylinder walls warmed up helps the oily piston rings slid over the cylinder walls. If it's exceptionaly cold putting a slow charge on the battery(s) will warm'em while improving their electrical energy. Never trid a magnetic heater. Although warm oil would help a crank shaft turn easier. But, You can use a lighter multi-grade engine oil to help here. Here's to making smoke.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|