Tractor Talk Discussion Board |
Re: 951 Ford steering
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Geo in SD on January 17, 2004 at 16:26:16 from (66.115.197.237):
In Reply to: 951 Ford steering posted by Fern(Mi) on January 16, 2004 at 09:32:45:
Fern: Are you talking about the steering gear at the steering wheel or the pedestal up front? If this is the steering wheel gearbox, yeah, sounds like it could be dry. Is there oil leaking around the pitman arm shaft? If so it probably is. Look right behind the battery tray at the steering gear. There should be a sort of flat area almost the same height as the battery. On top of this hump there is a plug. This is the filler plug.What I did on my 4000 was to remove this plug, drill and tap for a 1/8 in. pipe and install a grease fitting. Then I pumped it full of corn head grease, which is a soft, sticky grade 0 grease just for gearboxes. Takes about a tube and a half, and your seals won't leak anymore.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|