Tractor Talk Discussion Board |
Re: Ray, IN ,re: 6.5l diesel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on January 15, 2004 at 17:26:03 from (66.163.134.177):
In Reply to: Ray, IN ,re: 6.5l diesel posted by Red Tom on January 15, 2004 at 16:57:32:
The injectors can be calibrated if necessary by adding or removing shims. At $38.00 each for new ones often they are just replaced. So you paid the shop almost $500.00 labor for a couple of hour job to replace the injectors. Have you priced a set of HEUI injectors for a Powerstroke, and labor to install them? It's not pretty, either, and 'Stroke owners are faced with this after 100,000 to 150,000 miles. I'm not trying to start a brand-bashing thread here, just bringing up the point if you're gonna own a fuel burner, you better have deep pockets when it needs repairs. (And yes, I own several of them of assorted brands.)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|