|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Engine block heater
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on January 03, 2004 at 15:46:23 from (66.163.134.177):
In Reply to: Re: Re: Re: Re: Engine block heater posted by Danny Hearl on January 03, 2004 at 11:05:16:
Danny, I have gone on many heating service calls at 2:00 in the morning, and not at any wimpy 10 degrees. Here in northern North Dakota, it gets -30 below, as it is supposed to this weekend. Add the windchill to that, and it gets a bit nippy! That being said, I was not being a smart a$$. No one can tell you absolutely for sure what block heater is in your pickup. I have seen them for the Fords in several wattages. It would depend on what the factory happened to use, or it could have even been installed by the dealer before the initial sale. Therefore, I thought I was being reasonable in suggesting that you, as a qualified heating serviceman, would be in the unique position to have an AC ammeter with which you could determine the actual amperage, and would not have to guess!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
