|
Tractor Talk Discussion Board |
Re: Autolite Voltage Regulator
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon H on December 31, 2003 at 17:37:42 from (69.26.18.4):
In Reply to: Autolite Voltage Regulator posted by Richard Fazio on December 31, 2003 at 15:39:44:
Your description tells me that the fellow that did the alternator conversion on your Farmall used a regulator designed for the Delco external regulator alternator(Terminals marked F-2-3-4),as an Autolite regulator whould have terminals marked (I-A+-S-F).
No problem, the specs are close enough that a Delco regulator will do a good job controlling that Autolite alternator.
1 just hook the regulator #3 terminal to switched 12 volt power.
2 hook the regulator F terminal to the FLD stud on the alternator.
3 Run a ground wire from the ground stud on the alternator to one of the mounting bolts on the regulator.
If the FLD wire is shorted to ground anywhere between the regulator amd alternator,it will instantly destroy the regulator. Using a salvage yard regulator plug at the regulator will help prevent shorting the F terminal at the regulator. Also before installing your new regulator,you should check your alternators FLD/rotor terminal for excessive current drain. The rotor can be partially shorted which will burn out the new regulator. A small 12 volt battery charger((6-10 amp) works well.
Remove the FLD wire from it's alternator stud and connect the chargers pos clip to the FLD stud.Connect the chargers NEG clip to the alternator case. The chargers guage should read between 2-4 amps max. If it alternator passes this test,you should be OK to install the new regulator.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
