|
Tractor Talk Discussion Board |
Re: Re: Parts for JD 2010 gas Utility Industrial t
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill on December 26, 2003 at 03:22:48 from (152.163.253.66):
In Reply to: Re: Parts for JD 2010 gas Utility Industrial tract posted by fasting on December 25, 2003 at 17:48:03:
Not sure about the Ag vs. RU models. I need to look at this weekend. The yellow tractor/loader/backhoe hub that is cracked and worn out is the bright yellow tractor color and not an agriculture green or pale yellow color. This hub has the pointed square spline taper end on one side and is flat on face even with the rim on the other side which fits on a 29 inch spindel. I know there is a similiar hub that is the same square on one side but the outside face instead begin flat with the rim, points out similiar to the inside hub and fits on a 33 inch spindel. I have already replaced the spindel, but still looking for the hub. I will have to get more details. I am located in Pennsylvania and already tried Wensingers locally. The best information I have is the hub stamped number.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|