|
Tractor Talk Discussion Board |
Re: O.T. isulation and moister barrier.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ray on December 25, 2003 at 15:56:59 from (158.222.226.251):
In Reply to: O.T. isulation and moister barrier. posted by Chances R on December 25, 2003 at 07:19:21:
Hi, I have a moisture barrier horror story. I applied 6 mil visqueen (plastic sheeting) to half my house - then had "help" putting up sheetrock by someone who didn't believe in it. We didn't apply it to the cathedral ceiling. 15+ years later, I needed to reroof. I could put my hand through the roof plywood because it had been condensing on the north-facing roof for all those years. Had to replace some rafters, tear off all the plywood, rebuild and resheath the north roof. (Southern exposure of the solar oriented house was fine, moisture got baked out of the insulation every Summer.) Put in roof vents and rafter vents to allow moisture to escape to the outside. Either apply moisture barrier or provide very good ventilation to allow moisture to escape. In cold climates, I would always apply moisture barrier, because it helps keep the insulation dry, as mentioned in other posts. Barrier or vents, one or the other, I'd do barrier if I had it to do again. Just my well earned $0.02. Ray
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
