|
Tractor Talk Discussion Board |
Re: Just how danergous are tricycle front tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T.J.-N.J. on December 24, 2003 at 08:54:04 from (65.41.88.112):
In Reply to: Just how danergous are tricycle front tractors? posted by Lynn Kasdorf on December 24, 2003 at 07:23:42:
I have had a lot more concern about rearing up than going over. Most wide front end tractors have quite a lot of pivot built into the front axle mounting, and will lean way over any way. I have been a volunteer fireman for 19 years in farm country most of my experience with rollovers have almost all been involving loader tractors with the loader being to high while loaded. I think I have been on more accidents involving people getting run over than anything else, a lot of people get down to drop a pin in the hitch and forget to set the brake or it doesn't even work in the first place and back them selves over. Probably followed by getting tangled up in pto driven implements or shafts especially when the guards are off. Probably followed by ATV's and chainsaws. T.J.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|