|
Tractor Talk Discussion Board |
Re: Ford F150
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john on December 15, 2003 at 06:26:28 from (68.158.152.10):
In Reply to: Ford F150 posted by stan on December 14, 2003 at 21:01:10:
Pull the trans???
where is the slave cyl.-- on the inside of the bell housing????? My dad has a 98 or 99 F150 that he took in to have front end aligned because it was pulling. It cost him like $300.to $400. to have it done. There is no adjustments on the truck from the factory. You have to have the ajustments installed. My take on new car better Idea is.....
We have to make our cars last longer to compete with others so how can we make money. Lets see..... We can make cars that can not be repaired in a home garage or better yet we will make the parts needed so exclusive they will be dealer only parts. Very hard to compare maintenance cost at the time of car purchace.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
