Tractor Talk Discussion Board |
Re: Irrigation Well Bowls (long rant)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A on December 04, 2003 at 10:17:39 from (208.24.233.2):
In Reply to: Irrigation Well Bowls (long rant) posted by Allan on December 04, 2003 at 04:25:46:
Allan, In the late eighties we converted from row water to center piviots. In the OK panhandle. Useing HD 800 MM on natural gas. Pullin from 280/300 ft out of the Ogalla. Open flow test pumped 850/1000gpm. ( I don,t understand his 800 dollar charge ...for sticking a pipe W/ a meter on the end of a pipe of your hydrant. , Unless there is no power sourse at the well) Anyway...These wells could handle watering 80 acres of row watered corn...then it would be able to handle 120 acre center piviot. This is the rule of thumb we used on ours. Some of the Amarillo gearheads needed to be reworked for various reasons. No wells were pulled except a couple to clean the caseing. One well was Dryiced to inprove water production. Our Valleys were 9 tower, 1/4 milers 3 phase electris drives. Not a rotophase driven off the driveshaft. Our wells produced 18 lbs of pressure @ the piviot We also used pressure regulators to have better uniformity all along the sprinklers . They are even better now that they were converted to LEPA. Anyway I wonder if this well man was thinking he had a sleeper here , and thought he could slide one down on you? Our guy would throw that test pipe up in his pickup and come test a well for almost nothing. Be heads up on this guy. By the way you talk this guy isn't you regular well man. So be heads up in the future. Good Luck, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|