|
Tractor Talk Discussion Board |
Re: Glow Plugs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi on December 03, 2003 at 12:11:09 from (69.87.133.3):
In Reply to: Glow Plugs posted by Deutz Man on December 03, 2003 at 02:38:57:
First of all, none of the Deutz tractors i've owned have been "hard starters". So, maybe checking everything on yours to begin with would be a big help. (includeing compression) You can put synthetic 15w40 oil in yours for the winter, and that would help "a lot". I would NOT run 10W as was suggested. If you go to your AGCO dealer, the Agco Allis tractors (5600 series) they sold a few years ago had an "optional" 110v heater that went in the engine shroud to preheat the cylinders. One of my tractors has it, and i did plug it in a couple times just to see how it worked. It worked very well!! My tractors start good with out it, so i normally don't use it. I think at the time, they were $85.00 at the parts counter. I'm sure you would have to order one to get one. To install, all you do is hole saw a small hole in the engine shroud, and in it goes!! As was said, holding a heat gun or hair dryer in the intake will help too. I don't and "won't" use ether in any of my tractors!!! Robert
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|