|
Tractor Talk Discussion Board |
Re: Tracotor for a bad back and knees
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by HoneyRancher on December 01, 2003 at 20:17:09 from (63.189.1.125):
In Reply to: Tracotor for a bad back and knees posted by ONLYTONY on December 01, 2003 at 17:29:51:
I have a Kubota L2950 with a loader. That first step up to the operator's platform has been getting higher each year. This past summer I took a look under the tractor and found two braces for the loader that had two 1/2" holes directly below the platform where I step up. I got two pieces of 4x4 angle iron, drilled holes in both sides of the angle, bolted one to each side in those holes I found and bolted up a 2x12 plank under the tractor. It sticks out about to the outside of the rear wheels and makes a very easy intermediate step up to the main platform. The only thing I haven't taken care of is some rubber flaps so the rear wheel doesn't drop dirt or mud on the step. It was real easy and real cheap - about $5.00 for the angle and I had the plank in the barn. Hope this helps.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|