|
Tractor Talk Discussion Board |
Re: Snow Plowing w/ Back Blade...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry NE IL on December 01, 2003 at 17:54:54 from (152.163.253.66):
In Reply to: Snow Plowing w/ Back Blade... posted by Nick Trimbee on December 01, 2003 at 08:56:17:
I've always used a back blade or drag box. I never push in reverse, except to get to tight places or pile snow. If you've got a good one coming, don't wait 'til you've got 3' on the ground! Like the post b4, keep your speed up with the blade angled. If you can tilt the blade so that the cutting edge is behind the top of the blade, do it. It will make it less aggresive and you won't plow all your drive stone up with the snow. Overplow or you will run out of room in no time. I drag mine straight out, then push into a stockpile in reverse. Good luck, Larry
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
