|
Tractor Talk Discussion Board |
Re: pto adjustment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kenny on November 29, 2003 at 07:40:20 from (216.139.102.48):
In Reply to: pto adjustment posted by mike on November 29, 2003 at 05:29:51:
There is a plate with 4 bolts on bottom of transmission. About where foot plates are.
Inside is your PTO Clutch, has a notched adjustment nut. Roll PTO Clutch arround till you find Spring loaded pin in one of the notches. Depress pin & turn adjustment nut clockwise about 3 notches ( I use 2 flat blade screwdrivers) and see how lever works may need more??
Once you get it to click in and out next Question is will it hold??? If it will not hold under load you will have to split tractor & replace clutch disks.
If you get into more than adjustments probably will need a Shop Manual. If I can help just let me know. I'm in the process of rebuilding a 550 Gas right now. So I have the tools & parts & shop manual strung all over the wife's garage.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
