|
Tractor Talk Discussion Board |
Re: 3pt from scratch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old on November 23, 2003 at 11:44:33 from (63.189.32.201):
In Reply to: 3pt from scratch posted by Brian on November 22, 2003 at 20:58:51:
I built one for my Oliver 77 I used a set of ford 3 point arms and built the reat from junk I had around the place works very well. The main thing is to get them the same distance from the tractor and up and down. I used 2 cylinder one on each side but I didn't really need the 2 one would lift it ok. Hope this helps a little
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
