Tractor Talk Discussion Board |
Re: What's good for the Goose(neck)?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott on November 21, 2003 at 16:51:43 from (68.108.43.237):
In Reply to: What's good for the Goose(neck)? posted by Indydirtfarmer on November 21, 2003 at 02:45:30:
I pull both a Delta and a Better-Built gooseneck trailers. Both are 24' (20' flat + 4' flip-up dovetail). Both are rated at 14,000 GVW. All things considered, the Delta is a better trailer. I think the website is www.deltatrailers.com. They are made in Arkansas, but have dealers all over. Another thing, I have a 2003 Dodge 2500 4x4 with the high output Cummins and the best thing I have put on it is an exhaust brake. I can stop so much better pulling a load (or empty) and I don't have to depend on the service brakes as much. We pull in a mountainous region so I'm always concerned about getting my rig stopped.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|