|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Bleeding Fuel Lines
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on November 09, 2003 at 14:18:49 from (65.59.179.179):
In Reply to: Re: Re: Re: Re: Re: Bleeding Fuel Lines posted by G-MAN on November 08, 2003 at 12:10:10:
I learned something from my new PSD. When I ran out of fuel, bad sendor unit, I put in 5gal, opened the fuel filter drain, turned on the key (electric pump), bled the air and fuel into the 5gal can, then shut the filter drain, started right up with no problems. With that in mind, why couldn't you do the same on a non-electric pump system? Open the filter drain, add slight pressure to the fuel tank, thus bleeding the air and fuel into a fuel can. T_Bone
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
