Tractor Talk Discussion Board |
Re: oil
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan on October 25, 2003 at 04:37:53 from (148.63.132.164):
In Reply to: oil posted by R. Marg on October 24, 2003 at 20:59:00:
R Marg, My guess is that after warmup, the pressure would remain roughly the same either way, given we have a good sound engine. After it is warmed up, that engine does not care what the outside temperature is, it does not care what weight of oil is running and it does not care who manufactured the oil. Oil pressure is controlled by the oil pump pushing oil thru clearances at the crank & cam and all the while working against the resisting pressure of that oil pressure regulator spring. The critical time is the warmup time and this is where differing oil weights come into play (we've got to get lube to that engine's internal parts when it is cold); after the engine is to temp, there is almost "no" wear whatsoever in an internal combustion engine. All wear comes when she is cold. This is why you never want to buy a car from a little old lady who just used it to run a block and a half down to the post office. That engine's whole life has been nothing but constant abuse. :>) My 2 Cents, Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|