|
Tractor Talk Discussion Board |
Re: Re: a dumb question about LP gas tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greenbeanman on October 20, 2003 at 22:02:54 from (171.75.205.211):
In Reply to: Re: a dumb question about LP gas tractors posted by Larry on October 20, 2003 at 18:46:36:
Please consider ditching the use of the adjustable pliers as a safety measure. In the LP gas industry the correct procedure would be to use a nonferrous brass or aluminum wrench, so that no spark can by created by metal to metal hitting together. The rubber gasket in the filler valve should allow you to hand tighten the fitting without any wrench at all. Same for unhooking. You may need to use the side of the hose valve for a little extra leverage, but it should never take pliers. I'm not wanting to pick on you, I would rather have you around to post again however.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
