|
Tractor Talk Discussion Board |
Re: anyone ever moved a grain bin?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by iNDYDIRTFARMER on October 13, 2003 at 02:58:16 from (66.83.236.250):
In Reply to: anyone ever moved a grain bin? posted by markct on October 12, 2003 at 19:47:44:
Good morning all. I have built 4 new ones, and moved that many old ones. When you're building new, you start at the top. Each "ring" is assembled, and lifted with a "tri-pod" winch/jack. You can dis-assemble one the same way, but it's not very easy. The first 2 I moved, we set scaffolding INSIDE, and ladders on the outside. S-L-O-W-!!! The last 2, I contacted an "Aerial lift" company, that is "local". They picked them up with a helocopter. Moved them about twenty miles. Cost less than the labor involved in dis-assembling. BE CAREFUL IF THERE IS ANY RUSTED PANELS (ESPECIALLY NEAR THE BOTTOM) A panel or two, buckling under load, while dis-assembling a bin, can cause them to fall prematurely. Saw it happen.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|