Tractor Talk Discussion Board |
Re: perkins 4 cyl diesel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Woodbeef on October 10, 2003 at 06:29:05 from (207.164.209.120):
In Reply to: perkins 4 cyl diesel posted by stan on October 10, 2003 at 01:04:03:
Anything is possible if you have enough money to waste!! Go out to your tractor,and look at it from a side view. Now imagine that the engine is now oh....lets say 7" longer(this is a structural tractor so the lenght of motor makes a difference)Ok once you have envisioned the extra lenght,now look at every thing that must be modified to fit this 4 banger into your tractor......Now look under the hood and figure once again. Ok lets just say you did shoehorn the 4 banger in and got it bolted down(what does freakinstine now look like,eh?).......now will the tranny and rear end survive? Good luck!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|