Tractor Talk Discussion Board |
need your help
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old fashioned farmer on September 29, 2003 at 20:13:24 from (164.107.203.253):
Good day gentlemen, Well, I've exhausted all my conventional sources and so I come to y'all for a little help. I appreciate any you can offer. Here's my situation. I have an international hydraulic plow (not sure of the model). It is a four bottom but can be converted to a five bottom if desired. My trailing wheel is shot. The hole in the wheel for the valve stem is all rusted up and full of points that have punctured my tube. I have a good many acres to plow and only a two bottom j.d. trip plow to use behind my R. I could really use that four bottom. I've tried all my sources but cannot find a replacement wheel for it. Do any of you all know where I might find one or perhaps have one that you'd sell. I appreciate the help. God bless. --old fashioned farmer
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|