|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Leather Seals
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan in Ore on September 28, 2003 at 02:24:55 from (198.81.26.177):
In Reply to: Re: Re: Re: Leather Seals posted by george md on September 27, 2003 at 20:57:42:
Our machinist at work has that capability and doesn't mind doing things for people, however an F-14 axle shaft isn't something that you stick in your pocket so you can get it past the maintenance supervisor. I feel confident this will hold. I have used JB Weld on a lot of stuff and am convinced it is no less than great. I roughed up the shaft pretty good to give it something to grab on to and after I put the JB weld on I wrapped it with a piece of heavy card stock to keep it from running out. Then I put the small ring compressor around that to keep everything round. I have a tool post grinder for my South Bend 16 X 60 lathe so that should give me a good smooth surface to work with. Thanks for the info and the offer. Dan
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
