|
Tractor Talk Discussion Board |
Newbie looking for tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Spooner on September 23, 2003 at 04:28:41 from (63.113.151.30):
I imagine this question has been asked a million times here, but here goes again. I'm looking for a tractor. In my dream world, I truck on down to the local Deere or Ford dealer and buy a nice compact 4wd with bucket and brushhog and grader blade off of the lot. But, the budget does not allow for that. So I'm thinking something older, but still useful for what I want it for. I want it to maintain a 1000' dirt and gravel driveway, including removing snow. I want a brush hog to be able to earn some money up the street mowing the game club property. I want to drive around on my 14 acres of woods and carry rocks to build rock walls...and harvest firewood. I was dead set on a loader for a while, but now I'm not too sure. I think that I could do all of my driveway maintaining and rock moving with a rear dirt scoop...but one with a hyd upper link. I was dead set on 4wd, but now I'm not too sure. Using the dirt scoop would allieviate the need for 4wd (though my property is hilly and the 4wd would be a big bonus). I do want a live pto. I like the Ford 800's. In fact I like all of the older Fords, I'm just not too sure that the N's have enough oomph to pull that brush hog and I don't think that the N's have a live pto (but I'm a newbie...so what do I know?). I'm not adverse to any brand: JD, Case, MF, etc. Gas is fine with me...this is a homeowners tractor, not a farmowners. Ideally, I would be able to find this tractor in southern New England. Thanks for any input. Bob
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
