|
Tractor Talk Discussion Board |
Re: Re: Re: Re: JB Weld repair??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george md on September 15, 2003 at 18:47:30 from (67.74.226.157):
In Reply to: Re: Re: Re: JB Weld repair?? posted by Rod (NH) on September 12, 2003 at 16:38:24:
Rod , I talked to tech department at harris today and they admit that the Kastweld 111 or alloy cast weld is nonmachineable and they don't have any that is machineable .
After many hours on the phone today , I found a supplier in texas that says his is machineable , have a box on the way. They are a valve seat supplier for the automotive trade and also have the cast rod poured by a local foundry to their specs so that is is machineable . It's made for the repair of cyl heads that are cracked or otherwise damaged and has to be able to be machined to install valve seats . george
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
