Tractor Talk Discussion Board |
Re: John Deere 60 manifold bolts.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DRL on September 09, 2003 at 05:51:30 from (65.117.208.148):
In Reply to: John Deere 60 manifold bolts. posted by Dave Dunn on September 08, 2003 at 17:53:50:
Lots of Blaster, lots of patience. Work them on and off a little at a time, and if you are lucky, they'll come out. If one breaks off, or you are wanting to replace them, you will probably have to get the correct JD studs to replace them. Don't know about the numbered series, but I do know with the lettered series, they had a special thread. If you put regular stud bolts in them, they would leak. Also, if they are too long, you stand the chance of piercing the push rod tubes in the head and causing a leak into the crankcase. Holds true for the lettered series, may or may not for the numbered series.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|