|
Tractor Talk Discussion Board |
Re: International 606 info
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jay on September 04, 2003 at 18:19:01 from (66.231.126.34):
In Reply to: International 606 info posted by R. Brow on September 04, 2003 at 17:17:37:
Per my Chek-Chart book: HTF - which basically means Hy-Tran, Mobil 424 Fluid, Chevron 1000 Fluid, Exxon Hydro 560, etc. (These are the ones I'm familiar with and all quality products) Per book: To drain, remove 3 plugs at bottom and 1 at top right. Models without power take-off and torque amplifier have 2 plugs at bottom and 1 at top right. When refilling (52 quarts by the book), leave filler plug out, then move position control and auxilliary valve control levers back and forth 10 to 12 times and return position and auxilliary valve levers to forward position. Actuate auxilliary valve control levers to retract remote cylinders. With power steering turn wheel to both extremes and return to center. Stop engin and add additional fluid as required and install filler plug. Drain and refill every 1000 hours or yearly.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|