|
Tractor Talk Discussion Board |
Re: Closing in on us
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Texas Jay on August 22, 2003 at 21:53:11 from (152.163.252.71):
In Reply to: Closing in on us posted by Bring back the country, o on August 21, 2003 at 14:00:03:
You got every right to gripe. I fall in between you and those you complain of. I recently acquired about 30 acres. I grew up on much the same. My nearest neighbor is a couple hundred yds away, the next a half mile. I don't want any more. I have three young boys and they need more room than a back yard to run and grow in, like I did. I'd love to have more but it costs too much. Even ag land costs $2000-$5000 an acre unless you can find a whole, multi hundred acre place, again thanks to your city..."friends." So I can't be a farmer. I can't walk in your footsteps. But I value the same things you value. I'll raise my hay and run some cows and teach my boys to "ride, shoot straight and tell the truth." And yes I'll claim ag discounts and tax breaks where I can. I'd be a fool not to.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|