|
Tractor Talk Discussion Board |
Re: 1964 International 504
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on June 18, 2007 at 14:34:14 from (152.163.100.14):
In Reply to: Re: 1964 International 504 posted by the tractor vet on June 18, 2007 at 13:37:33:
I don't know what kind of loose ground you have in your area, but it will not pull 3 here, I have tried it with a rowcrop and utility. It takes a minimum of 50 HP to even pull 3X14s here. When I talk about plowing, and I have plowed a lot of ground with many different tractors, I am talking about fescue sod or wheat cover crop. That being said, I had a neighbor that pulled 3X14 with his 444 and he plowed about 4 to 5 inches deep. When I plow I run anywhere from 10 to 12 inches. We plowed for years here with a 4440 JD and 4X16 MF plow and it was ALL it would handle. I do know that in different ground A 4440 will pull 6, but not here.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
