|
Tractor Talk Discussion Board |
Kinkaid
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Buss on August 05, 2003 at 18:29:47 from (207.51.180.13):
Hello, I was at a friends shop the other day and he showed me a walk behind garden tractor the his gramps gave him. He remembers it running when he was a kid, probably 40 years ago. This tractor seems quite old. On the handlebars it says Kinkaid Implement Co. It is a real solid piece that is completely covered with surface rust. It has a single steel wheel that is approximately 20'' in diameter with about 1'' pyramid shaped studs on it. The rear section of this ...thing... pivots just behind the motor and rides on two 6'' casters that set just far enough in front of the handlebars so the operator can walk without interference. The motor is placed almost inside of the steel wheel. The wheel has a large "drum" that I would assume has a ring gear inside and is driven by a gear or gears off the crankshaft. The really cool thing about this machine is an extra studded steel wheel that has about a 3' axle that is contained inside a housing. The axle bolts to the other (drive) wheel. You can bolt implements to the housing that of course will hang out the side (right side) without interfearing with the operator. He has a plow and disc that bolt onto this housing. In fact the lift arm for the plow looks like it is set up to give the plow extra tilt fot the first furrow????????? The engine crankcase is massive. I couldn't see any I.D. on the engine. Does anyone have any info on a machine like this. Funny ting. I have been an avid antique motorcyclist for years and have never posted any messages to the tech groups. This Kinkaid really has me shook up. Thanks, Buss
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|