Tractor Talk Discussion Board |
Re: Re: Re: help on repairing my farmall m
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TimC on July 31, 2003 at 20:11:31 from (199.91.33.254):
In Reply to: Re: Re: help on repairing my farmall m posted by J.T.Moore on July 30, 2003 at 14:09:12:
A compression guage could tell you a lot. I'm sure you could borrow one from a friend to make sure you have decent compression. Once in a while you will run across an engine that has set up that just will not start with out a new set of plugs. I (actually my dad) have an allis G that had 1 year old plugs in it and after the winter it wouldn't hit a lick. We stuck a couple used plugs in and it started hitting but just would not run until 4 new ones were installed. I just rebuilt a 53 Jubilee that was blowing oil really bad. It started just fine until i rebuilt it and the plugs refused to fire under increased compression. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|