Tractor Talk Discussion Board |
Re: Re: Darn Square nuts/bolts!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry A. on July 29, 2003 at 06:02:38 from (216.125.105.158):
In Reply to: Re: Darn Square nuts/bolts! posted by wdTom on July 28, 2003 at 18:25:51:
Couldn't have put it better myself. Roger Welsch says basically the same thing in his first "tractor book" (I'm still laughing at some of his lines...). The "average" farmer in the 20's and 30's had very limited experience and tools. In addition, the tolerances for making a sqare nut were lower (I've seen some that weren't really square; I think they sheared off steel strapping and threaded crude holes). My grandfather could adjust/fix most of the old implemennts and tractors with a cresent wrench and a monkey wrench (his favorite). Tough to do that today. The stuff served it purpose. The fact that all this old iron hasn't completely rusted away after 60 + years under the hedge trees is a testament to the quality of steel/iron in that equipment.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|