Tractor Talk Discussion Board |
Re: Electronic Rust Protection
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Deas Plant. on July 23, 2003 at 04:04:12 from (210.50.57.83):
In Reply to: Electronic Rust Protection posted by RJT on July 22, 2003 at 05:12:31:
Hi, RJT. When the first ERP's were introduced to Australia in about 1993 or so, the company who sold them fitted two of them to NEW surf club beach patrol 4 wd's. The surf clubs were pulling spray-on rust protection coated new vehicles out of the line after 6-8 months to repair rust. After 12 months, there was NO rust in the two vehicles fitted with the ERP units. ALL of these vehicles work on beach patrol 7 days a week. These tests were monitored by the University of Queensland Technology Dept. Do your homework. As with most other things, I'd guess there would be some that work better than others. Hope this helps. You have a wonderful day. Best wishes. Deas Plant.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|