Tractor Talk Discussion Board |
Re: Differences between 1950, 1951 and 1952
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim.UT on July 15, 2003 at 11:45:01 from (64.122.18.247):
In Reply to: Differences between 1950, 1951 and 1952 posted by Terry on July 15, 2003 at 08:08:00:
There were some changes made during those years. That model of Ford is known as the 8N and was built from 1948 (actually starting in June 1947) until late 1952. Along the way some upgrades that occurred were better steering gear, better clutch linkage, Ford script started appearing on the fenders, front mount distributor was replace with a side mount, proofmeter was added to the dash. I think there was a change in the transmission gearing somewhere along the way, too. How to tell the year. Well there are a number of clues. The first thing to check is the serial number. It's located on the left side of the engine block on a rectangular flat pad up near the head. It's hand-stamped and sometimes the numbers are pretty faint. There are date codes on various pieces on the tractor. The easiest one to decipher is on the hydraulic pump. Crawl under the tractor armed with a rag, wire brush and some spray degreaser. Clean off the spot right next to the drain plug. There should be a date stamped there. That's the date the pump was built, not necessarily the date the tractor was assembled, but it will probably put you in the correct year. All this and more you can learn by clicking here to read John Smith's dissertation (with photos) on how to identify an N series Ford tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|