Tractor Talk Discussion Board |
Re: Re: How to PLOW
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on June 11, 2003 at 09:37:19 from (66.60.197.104):
In Reply to: Re: How to PLOW posted by Dana on June 11, 2003 at 09:16:53:
A plow throws dirt to one side. So when you start plowing, you will make a ridge to the right, & a valley on the left. The first time through, you need to set the plow to go deeper on the right side. After that, you put the tractor wheels in the furrow, and plowing is easier. You need to have the plow lined up behind that wheel so the dirt flows properly. You can plow back & forth sort of, either throwing the dirt into a ridge on each side & ending with a furrow (valley) in the middle; or you can throw the dirt into a ridge in the middle as you go around, and end up with a furrow on each side. As you make rounds, you are always going clockwise or counterclockwise in a bigger or smaller round. You are not plowing back & forth right next to the previous 1/2 round. Every other year, you fill in your valleys by plowing in the opposite way. As stated, for 6' I would just make one ridge, and then plow in one direction, coming back empty. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|