Tractor Talk Discussion Board |
Re: JD 2630
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Terry in KY on June 06, 2003 at 08:34:31 from (162.114.211.143):
In Reply to: JD 2630 posted by Dieselrider on June 06, 2003 at 03:36:01:
We've had a 2630 for about 20 years and will probably have it for 20 more. These tractors are small enough to use for everyday jobs and have enough muscle for bigger jobs. I can't remember the JD engine number, but I know JD used that engine for several years in other tractors and even dozers and backhoes. We have a 1985 550B dozer that has the same engine with a turbo on it. These engines are very fuel efficient, but put out a lot of torgue in a small package. These tractors were Cadillacs in their day. The seat is comfortable and every lever and control is within hands reach, no stretching needed. You can turn the steering wheel with your pinky. All these things make a difference if you drive a tractor all day long. The hydraulic remote has a float function which allows cylinders to move as they please, which is great on implements like our pull type corn planter or 2 row tobacco setter which need to follow the contour of the land. As far as problems, as with all sleeved engines you need to change the antifreeze regularly and keep additive in it to keep the sleeves from pitting. The water pump bearings are a little undersized, so you have to watch for them to get loose. JD sells rebuild kits for them, no need to buy a new waterpump. Finally, the Delco starters weren't big enough because these engines are hard to turn over and the starter sits very close to the engine and picks up a lot of heat. JD now sells gear reduction starters which actually cost a little less than the Delco and last 10 times longer. We love our 2630. It's done a lot of work on our farm and made us a lot of money.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|