|
Tractor Talk Discussion Board |
Farmall H Hydraulic Pump
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick on June 03, 2003 at 20:08:17 from (12.223.136.218):
I have a live hydraulic pump I bought for my 44 H. It actually bolts up behind the spool piece between the distributor and the oil fill. The pump is a Case VT609. It is a 2 bolt flange on both sides, and has impulses on both the input and the output. The input seal has a small leak. I can fill the pump with 30 W oil on the bench and it will leak about an ounce of oil after about 10 hours. The input impulse has a castle nut holding the impluse on, and it must be removed to disassemble the pump. Does anyone know if there is a special tool to remove this nut. There is no clearence to get a socket on it. Any help would be appreciated.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
