Tractor Talk Discussion Board |
Re: homemade roller questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on May 23, 2003 at 08:16:53 from (216.28.210.137):
In Reply to: homemade roller questions posted by Lynn Kasdorf- Leesburg, VA on May 22, 2003 at 07:48:45:
I'm surprised at the misconceptions of calcium. It is added for two reasons, it makes the water heavier which is the goal(weight) and it keeps the water from freezing which would destroy the tire and rim. Calcium is extremely corrosive to metal and if spilled will kill any vegitation.For these reasons calcium is slowly being replaced as a tire weight with non corrosive liquids like used anti-freeze or a substance that resembles windshild washer fluid. As far as your roller idea, I doubt it will help much. Do it right and rent a vibratory plate compactor.Thats what they are designed to do and will give the best results.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|