Tractor Talk Discussion Board |
Re: homemade roller questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by VaTom on May 22, 2003 at 11:03:18 from (64.4.123.18):
In Reply to: homemade roller questions posted by Lynn Kasdorf- Leesburg, VA on May 22, 2003 at 07:48:45:
Hi Lynn, Are you using stone with dust in it? I don't have any suggestions for your roller as I've never seen the need for one. An experience with VDOT convinced me. They required the dust for a driveway entrance I put in. There was standing water and I KNEW I was going to be back with large stone later. Wrong! The dust and stone combination set up like a rock. Around here the dust is essentially free, but for the hauling expense, as the washed stone costs a lot more. The quarry here recommends stone with dust for all driveways. My experience is that it works great. Only problem I've had was one customer who insisted on washed stone. His driveway still isn't right.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|