|
Tractor Talk Discussion Board |
Re: Mini excavator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TimV on May 07, 2003 at 06:13:46 from (12.39.239.130):
In Reply to: Mini excavator posted by Dave on May 07, 2003 at 04:28:05:
Dave: I've had a bit of seat time in a couple of these, and it's amazing the amount of work you can do with one. I've also owned a full-size backhoe, and while the full-size machine is faster (at least the actual digging) the little trackhoe will move short distances (like along a trench) faster, and requires less set-up time once you get there--just lower the blade and dig. It's the cat's pajamas for ditching and backfilling, small excavations, and similar chores. There are very few things that the typical 3-point mounted hoe can do that the small excavator cannot, particularly as the 3-point backhoe is not a purpose-built machine like a full-blown TLB setup. The main flip side is cost. If you already have a tractor, it's a lot cheaper to buy a backhoe, even a new one, than it is to buy the entire machine. One possibility is Northern Tool--in the last year or two they've started offering used mini-excavators from about $12,000 and up. Their website has some details, their catalog has more, and I'm sure you could get even more if you're serious about purchasing one. They also offer new 3-point backhoes if you want to go that route. I can't vouch for their quality--I've had no experience with their excavators, but I do own one of their Trencherman II's, and I've been VERY happy with that.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|