|
Tractor Talk Discussion Board |
Re: stumpjumper
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mdm on April 30, 2003 at 11:56:31 from (65.208.22.25):
In Reply to: stumpjumper posted by stuck and stoned on April 23, 2003 at 21:06:35:
I see three things you could have done. 1. Bent the shaft 2. Bent the stump jumper 3. Misaligned the gear box by bending/cracking the deck/gear box mount, elongated/enlarged gear box mounting bolt holes. With cases 1 & 2, you will see a "wobble" as the stump jumper rotates. To determine whether it is the shaft or the stump jumper you may have to remove the stump jumper so you can measure radial end play on the shaft. Either of these problems can cause vibration. If the vibration is intense enough, you can cause further damage to the brushhog and possibly the pto shaft, pto and other tractor drive train components. If things break loose, you are a potential emergency room visitor (or worse). In case 3, the stump jumper will not "wobble" as it rotates. The high point will stay in the same place in relation to the deck. If the deck/gear box mount is bent, there may be cracks or broken parts that need attention. The cracks or broken parts may allow movement of the gear box during operation. Elongated/enlarged bolt holes can also allow movement of the gear box during operation. Gear box movement during operation can cause vibration, increasing damage as you continue to use the brushhog. And again you can cause damage to the pto shaft, pto, and other tractor drive train components. Take the time to find out just what is damaged and take care of it. Farming has the second highest fatality rate of any industry in the country. Only mining is worse. Continuing to use unsafe equipment will help us beat miners in fatalities. mdm
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|