|
Tractor Talk Discussion Board |
Re: Having trouble with Farmal B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary-Miss on April 26, 2003 at 10:22:22 from (205.188.209.105):
In Reply to: Having trouble with Farmal B posted by Arte on April 26, 2003 at 09:21:16:
It really sounds like you are running out of gas. You didn;t say whether it was a distillate or straight gas. Distillate has the adjustable load jet in the bottom. Straight gas does not. Take the plug out of the bottom of the carb. This is the very bottom of the bowl. ee how long the gas runs out. After the first spoonful runs out ( the dregs), you can save the rest of it if you want. Run at least a pint out if it runs out. Make sure it doesn't slow down to a dribble. If it continues to run out good, you've got problems in the bottom of your carburetor. Sometimes you can confirm this by either turning the idle all of the way in to force it to bring gas through the idle circuit. (Airplanes don't have chokes. They always crank at idle) or choke it, or both. I pulled one off a 429yesterday twice, knowing there wasn't a problem with it. Just had to answer my question. There wasn't. It was the condenser. I finally confirmed it by pulling the coil wire out of the distributor enough to see thespark jump. When it messed up, but, before it stopped turning, I saw the spark stop. If it had been easy, the man would have fixed it himself.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|