Tractor Talk Discussion Board |
FORD-4400 DISTRIBUTOR 1965/ DID YOU KNOW???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jimp on April 18, 2003 at 07:19:31 from (209.213.208.142):
I have a 1965 ford 4400 and I have been trying to buy a tune-up kit.I have purchased 2 different kits over the internet and neither one fit my tractor.My distributor is a mallory YL711A/new holland F0NN12100AA and here's the kicker; the points,cap and rotor will no longer fit this distributor.The points and rotor and cap was changed to a cap with 6 terminals (3 are plugged),the points are smaller and the timing is different then that specified in the repair manual.If you buy an older repair kit for this distributor it will not fit.Just thought I would pass this along.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|