|
Tractor Talk Discussion Board |
Re: grass burning?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by smoke eater on April 08, 2003 at 14:15:30 from (66.187.42.12):
In Reply to: grass burning? posted by Randy on April 08, 2003 at 10:48:03:
have done this with 5 very good firefighters. Having more helps but never underestimate the wind and conditions. We burned around the entire perimeter starting downwind and working our way upwind giving us greater control of the spread. Once all the way around we began setting small pieces again from the downwind side,working against the wind. When we thought we had a good enough break we set the middle off. It took less time to burn the center especially when we ignighted the upwind edge. When the two fire lines came together there were flames at least 30 feet high. On purpose, we doubled the downwind break size. Keep in mind that as the grass burns off, it throws plenty of embers in the hot gases so watch where they fall as you go. An old tire on a chain dragged across the fire line will help snuff it in event it becomes out of control. Be sure to check your local FD for size limitations. 5 acres may be the cut off to also notify your department of natural resources because of the wildland fire parameters. The disc firebreak is not a bad idea but watch those flying embers. We had rain an entire week after I burned and three weeks after my pasture looked like velvet. Good luck and you can never be too safe. Don't underestimate your potential. I would bet you will be responsible for the burn, the aftermath, and suppression by your local department. Good Luck
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|