|
Tractor Talk Discussion Board |
Re: HP recommendations for front end loader?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on April 02, 2003 at 07:00:10 from (209.23.145.38):
In Reply to: HP recommendations for front end loader? posted by Tim Again! on April 01, 2003 at 15:58:26:
Hp doesn't matter. You need to figure out how much you need to lift. Loader tractors go from 18hp sub compacts to 150hp monsters that give commercial payloaders a run for their money. How much weight do you want to lift, how high, how much traction do you need, and how strong are your arms? Weight - bigger tractor can often handle a bigger loader. The front axle is the important part. Also important is hyd output & available ports. Will the loader use it's own dedicated pump, or will you try to plumb into what the tractor has - does it then have enough psi, volume, and control levers? Traction - are you working on hard flat surfaces, or dirt, or wet manure? Tire type, front wheel assist, and rear weighting is all important here. A bigger tractor will give better traction because it is heavier. Arm strength - power steering is not absolutly totally needed on a loader, but it sure is nice! Hp really doesn't come into it much. You'll be using the low gears for loader work, any tractor should have enough hp for a loader. If you are looking at a belly mount mower, those don't always work well with a loader. Just something to watch for. Actually for a mower, you want a light small tractor with smooth tires. For loader work you want a big heavy weighted tractor with agressive tires - hard to make the best of both worlds on one machine. Seems to be the 2 things people want most of a tractor, & the hardest to combine. Only you can know the best trade-off for your situation. --->Paul
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|